Checking the backlash in the rotation table

Published Jan. 10, 2018, noon

<p>The backlash on the rotation table can be cancelled out in the LinuxCNC software. The physical backlash is still there, mind you, and some cuts will pull the backlash out of the screw and ruin the part so I still need to be carefull. Programming the backlash out using software is not the full solution.</p>

Checking the backlash in the rotation table

This photo is found in the following galleries:

Checking the backlash in the x-axis Watch Case Progress Centering the rotation table on the mill table