Midway through engraving

Published June 9, 2016, 1:18 p.m.

<p>I put in the design outline with a detailing 96 degree point graver. I make a light cut to begin with in case I make any mistakes! In this shot I&#39;ve also removed some of the background, for which I use progressively larger flat gravers until its as flat as possible. The circular plant pattern around the omega was cut out with a thin knife-edge graver</p>

Midway through engraving

This photo is found in the following galleries:

Whole cross with central pieces complete again but with some perspective Enamel Cross Project Right-hand section finished engraving