A selection of Mark's enamel work
Rectangular Enamel Box
The finished enamel box, but the starting point for many miniature paintings!

2013

Rectangular Enamel Box

The lid and the base are made from copper which has been press formed into shape. The mount is machined from solid brass plate and then polished to give a lasting shine. The actual dimensions of the box (including the mount) are 84mm x 66mm with 31mm height. There may be some slight variation as all the boxes and mounts are individually crafted.

The piece

The finished enamel box, closed
The finished enamel box, opened
Side view of the opened enamel box
Top-view of my enamel box

How it was made

Heating up the copper sheet ready for annealing, for making the enamel box
Annealing the copper: heating over the stove.
Heating the copper sheet ready for annealing
Annealing the copper by quenching into water
Annealing the copper: quenching into water.
The copper sheet now rapidly cooled down in the water bath
The deep-drawing die set up to make the copper boxes
This is the deep draw die that I made, it's made from mild steel. …
Deep draw die set=up
Deep draw die with the pieces in place
The top section is the female part and holds the copper in place. When …
The hydraulic press with the deepdraw die set up ready to press out the copper formed box base
Here's the hydraulic press, looking very new in my workshop (also new) in Swindon.
Adding pressure to the deep draw press
The screen is there for the just-in-case scenario!
The copper base for the enamel box after coming out of the deep-draw press and cutting off the excess copper at the top
This is the base of the box, I've cut off the lower section of …

Used for