A selection of Mark's enamel work
Enamel Cross Front Page
The finished cross. It's comprised of six pieces that all fit together like a jigsaw.

2016

Medieval Enamel Cross

This was a commission to produce a medieval-style cross with enamel champlevé decoration. I needed to learn how to engrave to accomplish this work. I practised before I began and then started on the bottom section but decided that I would do the bottom section again if, by the end of the project, that section was not as good as the rest. However I was being too pessimistic, it came out really well, I got better with time though even so and got faster.
The cross is 14 inches tall and 8 inches wide. The piece was done in six interlocking sections with the joint becoming part of the design. Each piece was fired about 8 times making roughly 50 firings in all.

The enamel surface

Close-up of the right-hand section and adjacent sections
Here's the section with the adjacent sections put together.
Centre piece for the enamel cross
This is the centre piece of the cross all finished. It's been ground flat, fired to a gloss and then polished to a satin finish.
Top Piece of Enamel Cross
The top section of the cross.
Alpha Piece of Enamel Cross
This is the left-hand arm of the cross showing the alpha.
Omega Piece of Enamel Cross
The Omega right-hand section of the cross
Stem Piece of Enamel Cross
The stem piece of the enamel cross.
Bottom Piece of Enamel Cross
The bottom section of the enamel cross.
Signature on the Stem Piece
I put my signature on all the pieces, this shows the one on the stem.

The piece

Enamel Cross Front Page
The enamel cross with the background cleaned up
The Medieval Enamel Cross finished piece
Whole cross from the top down view
Whole cross from the top down view
Whole cross from the top down view with separation
Whole cross from the top down view with separation.
Finished Cross (with cleaned up background)
I took out the background with a graphics editor called GIMP and gave it a gradient shading, not sure how I managed it, or if I could do it again! Anyway I think it presents the cross rather well!
The Medieval Enamel Cross before the final polish and clean-up
Before the final polish and clean-up.
The Medieval Enamel Cross catching the light to highlight the shiny metal parts more than the enamel
All the Pieces with the nails

Written about

How it was made

Cross Shape
This is the shape I drew-up based on the shape that the customer has …
Entwining Patterns
Some experimental entwinning patterns. From left to right we have: 1. design cut into …
Initial Design for cross
The customer was not too keen on this design, she wanted a more medieval …
My second design for the piece
The customer is happy with this design. It's challenging - but I do tend …
Border Crosses Sampler
Experimenting with cutting some cross-shapes on the border. They've geen cut out with a …
Lower piece cut to shape
I made this section on my Sherline Mill.
Roughly cutting out the sizes of metal required
Very rough sizing up of the metal pieces. Only thing to be cautious of …
Check it fits the design
Bottom piece marked out
In pencil, the lower piece is marked out onto Chinese white water colour.
Lower and mid-section pushed together
Yep, that's a good join!