A selection of Mark's enamel work

Making a Watch Case · 11 of 21

Making a watch case (part 10), fitting the watch glass

18 January 2018

Watch glass curvature
Watch glass showing the curvature

Let's get the top of the watch finished, it's getting to look more and more like a watch so I'm getting quite excited!

This watch glass, above, is slightly domed and I wanted the top section of the watch to match the curvature and continue it to the edge of the watch. I fitted an ellipsoid curve to the curvature in the watch glass shown in the above photo. I'll write another post on that in the future, but I used Blender to do the modelling and made the curve by programming the mathematical formula into a python function and then tweaked the parameters, of the ellipse, until it fit.

First things first, though, I'll make the shelf for the watch glass to sit, here's the lathe set up (next photo). For some reason I'm using a four jaw independent chuck to centre the piece, so all the clamps are adjustable independently. I think,...erm, yes, it looks as if I've already cut some of the watch glass shelf by the time I took this photo, hence the need for the independent chuck to re-centre the ring exactly, and put the ring back on the lathe to widen the cut

setting up the lathe to cut the watch glass shelf.

The fitting of the watch glass is by compression, so the dimensions need to be spot on.

See the lathe cutting bit is angled so that the belly of the cutter is away from the inside edge of the ring. This allows me to cut a vertical side when the cutter is drawn out:

See the angle of the cutter.

I'm constantly using the calipers to check the diameter of the cut

Checking the diameter of the cut.

The watch glass has a diameter of 43.98mm, so it's quite a large glass for this initial design!

Watch glass diameter.

These dimensions might do it: the watch glass is 0.07mm wider than the space I've made so I take the ring off the lathe and try to fit the glass

The watch glass cut.

Notice that some of the screw holes are showing through into the watch-glass shelf. I didn't want this so I'm going to have to improve this in the next version.

I tried fitting the watch glass into the ring

Fitting the watch glass into the ring,

but it wouldn't go. The no point trying too hard, something's bound to break!

I put the ring back onto the lathe and using wet'n'dry paper and Shah stone (water-of-Ary stone substitute) to grind and polish the watch shelf and try to open it out very slightly

Grinding and polishing the watch shelf.

This bit took a bit of to-ing and fro-ing from the lathe back to the watch glass press and I took quite a few photos. I think this one is the one I took on the occasion that the glass did fit:

The watch glass will fit this time!.

So now I've got this

The watch glass fit into the ring,

but it wasn't easy!

Note to myself: It may be beneficial to make the glass shelf sides taper very slightly outwards to aid the fitting of the glass. The glass itself does have rounded edges so this obviously helps too. The taper, though, would have to be just enough to help put the glass in but not too much otherwise the glass may pop out too easily.

The next thing is to put a continuation of the domed shape into the outside corner of the top section

Top of the watch seen from the side.

Since I'm approximating the domed glass to be an ellipse, that means cutting the portion of the ellipse that I need into the corner section of the ring. To cut an ellipse I need cnc.

 

The work