A selection of Mark's enamel work
Watch Case with cloisonné frog dial
This is a prototype watch case, made from brass, to help design a watch case suitable for enamel dials. It as a domed glass front because I plan to dome the enamel dials. For this one I've put the cloisonné frog as a temporary dial. At this stage the watch doesn't have a movement and, as you can see, there are no hands or provision for a winder. Being critical, there is some dirt that has got in-between the glass and case and the lathe work gave out some chatter on the shelf that holds the face glass - so plenty of room for improvement!

2018

The First Watch Case

A Gallery to show the process of discovering how to make a watch case. Very useful for me to see what I did when coming back to this in future. I'll add more descriptions shortly, there's quite a bit of catching up to do - been busy lately!

The piece

Watch and movement
This is how the movement will be fit inside. Here I've got an inexpensive, unbranded, Chinese movement that I'm trying out for this initial design prototype.

How it was made

Starting with some brass plate
Cutting metal from stock
Fine adjustment to cut the bar straight
Cutting the bar on the bandsaw
First bar cut
Three bars cut
Stake for hammering the ring
Hammering the bar into a ring
Annealing the bar with a torch
Bar cooling a bit before quenching

Written about

Read the whole Making a Dial series →
Read the whole Making a Watch Case series →

Made using

Used for