A selection of Mark's enamel work

Making a Watch Case · 7 of 21

Making a watch case (part 6), soldering the lugs

10 October 2017

Using helping hands to put on the flux
Using helping hands to put on the flux

To solder the lugs onto the centre watch section I'm using a ribbon of hard silver solder and borax flux. The helping hands make things a lot easier as the watch ring needs to stay in the same position. The lugs fit well enough in the ring not to fall over.

close-up of the joint.

I dry the flux out on the helping hands using a propane torch, gentle heat is enough just to make the solder dry out without bubbling too much.

Once the flux is dried it acts rather like a weak glue so, once cooled, I've placed the ring into the soldering blocks like this:

ring placed into the soldering block.

This set up will help to shield the rest of the ring from too much heat. I don't want to melt the solder joint that keeps the ring together. It's difficult to see in the photo but there are some ribbons of solder underneath all that flux.

The joints are soldered and then I repeat the process with the second set of lugs

Second set of lugs fluxed and ready to solder.

As before, the flux is dried on the ring before I move it into position amongst the solder blocks:

solder block set up to shield the ring.

Now moderate heat can be applied and the previous joints should be reasonably shielded from the torch

Soldering the second joint.

The whole ring needs to get hot, but I only want the solder at the exposed joints to flow. Once done it looks like this

soldering the lugs is done,

the lugs have soldered very nearly perfectly vertical. However, there is a slight off vertical lilt to the right-hand lug. In future I might make the notches a little deeper to give a bit more support to the lugs; it's only a minor slant and barely noticeable, otherwise I'm happy with the result.

 

 

The work