A selection of Mark's enamel work
All the components for St. Cecilia
All the components for St. Cecilia

2019

The Chorister Medal Cases

Adapting the watch case design that I made earlier was incredibly tricky. I had to go from using a lathe to using the mill, simply because the medals were elliptical. The change meant that all of the g-code had to be re-written.

The piece

All the components for St. Kyneburgha
All the components for St. Kyneburgha

Written about

How it was made

St. Kyneburgha initial design
This shows a pencil drawing of the design idea for the St. Kyneburgha medal. …
St. Cecilia initial design
This shows the initial design for the medal which will depict Saint Cecilia. The …
Ribbon connection, lugs or ring?
Just a quick sketch to help decide whether the ribbon connection should be a …
Initial design for the medal casing
Doing some drawings helps to visualize the object and to communicate to the customer.
Detailed dimensions for the design
I put my design down on paper to get a better feel for what …
Positioning the casing in the vice
This is the elliptical mid-section casing positioning in the mill. Prior to this the …
Cutting notches for the lugs
I cut some notches for the lugs to sit in, the idea is to …
Preparing the lug section
I used the same sized pieces of metal for the lugs and the ribbon …
Preparing the lug section 2
Lug section with the inside curvature cut
The lug piece (that will be made much shorter later) with the inside curvature …

Used for