A selection of Mark's enamel work
Both the inscriptions place side by side.
Both of the engravings are done by hand but I used an etched script as a guide.

2019

Hand Engraving Script

When I've done engraving before, like when I'm putting in some tracks for cloisonné wires, I just trace the lines onto the piece using pencil and then used these as guides for the engraving. The lines are usually easy to follow, but with engraving script I found the amount of curving and close-proximity of the engraving tends to wipe-off any pencil with my hand so that's pretty much useless. So instead I explored etching some guiding characters onto the metal.
So what follows are some photographic notes on my exploring this area, along with getting the engraving ready for the backplate of the Chorister Medals.

The piece

The finished engraving for St. Kyneburgha
I practised for a long time to engrave the characters, the etching guide was essential for following the line. I made extensive use of the reference book "The Art of Engraving by James B. Meek" to get the script. I'm pleased with the result - but I think I can do better!
Saint Cecilia medal showing the engraving on the reverse
The finished engraving for St. Cecilia.

How it was made

Dark print of lettering onto transparency and the resultant mask
Dark print of the lettering onto transparency and the resultant mask created by exposing …
Hardening off the mask under the UV lamp
Hardening off the mask under a UV lamp. The mask is going to protect …
Using duct tape to stick the metal plate to the underside of the float
I stuck the sample piece onto the underside of float using the all important …
Putting face down in Ferric Chloride
Putting the float assembly face down into the tub of Ferric Chloride (iron(III) chloride, …
How the metal and mask look after etching
After etching, I don't have the time recorded for this one
Neutralising in a tub of Caustic Soda
Now nuetralising in a tub of Caustic Soda
The Caustic Soda destroys the mask.
The Caustic Soda destroys the mask.
The metal showing no perceptible etching.
There's no perceptible etching on the metal, I didn't leave it for long enough.
Success! I can see very faint etching marks
After cleaning up I can see a very faint etch, so it's a good …
Take two, showing the mask with the broken bits filled in with black permanent marker
Here's take two. The black sections are where I've marked the metal with a …

Used for