A selection of Mark's enamel work
Spray booth setup from the front
To enamel the steel I'm going to spray wet-process enamel. First the groundcoat followed by the opaque white. I got my wet process enamel this time from WG Ball but I've also got a pack of groundcoat, that I've yet to try, from M&CT vitreous enamels . To spray the enamels I need to manage the dust, i.e., use a spray booth. This is a wet backed spray-booth made from an old dishwasher. The pump pushes the water around so that is runs down the white ramp at the back. This captures the overspray of enamel and washes it into the filter at the bottom. This dishwasher's waste-out pump was still useable too so this pumps the water out of the booth when finished.

A Spray Booth from an Old Dishwasher

Workshop equipment: an old dishwasher converted into a spray booth for applying ground coat and opaque enamel. Used for the elliptical plaques and for spraying enamel boxes.

Written about

How it was made

The side view of the spray booth
Spray booth from the back
This shows the dust sock that filters any enamel particles that don't get captured …
Spray booth ready for next piece
The first side of the steel has been coated with the groundcoat and dried, …

Used for