A selection of Mark's enamel work
Surface quality test
I look at the reflection of the window in the enamel. Here it's quite sharp. The enamel-on-steel has this slightly ripply effect which, for example, enamel-on-copper doesn't have. The enamel-on-copper is completely smooth. I don't know if there's any way to eliminate this effect, it's minor really, but I tried adding more enamel, grinding, and so on but it always came back with this ripply surface. Of the eight ellipse that I made I've got four that are flat and have a perfect surface, with no bubbles, cracks or other defects. So I've still got some way to go in perfecting this technique!

2018

Elliptical Enamel Plaques

These elliptical enamel plaques are 150mm by 90mm for the major and minor axis. They're made out of low carbon steel and enamelled with steel ground coat followed by opaque enamel. Here's some photos showing how they were made.

The enamel surface

Groundcoat sprayed close up

Written about

How it was made

Rough Cut Ellipses
Low-carbon steel cut into rough elliptical shapes.
Plywood Ellipse clamp
Cutting an ellipse shape out of plywood for clamping the steel whilst it's cut.
Clamping so the back side can be cut
This is the set up for clamping so I can cut the back side …
Close up of cutting the steel ellipse
Showing the steel clamped between the two plywood clamps whilst it's being cut to …
Clamping for cutting at the front
This is the set-up for clamping the work whilst cutting the front of the …
A view of my Sherline mill cutting the ellipses.
A view looking down one side of the workshop whilst the Sherline mill cuts …
Cut out ellipse
The ellipse after it's been cut out from the mill.
Deburring the metal
Some deburring required on the sides, this may mean the cutter is not sharp …
Cutting the back of four pieces at once
Now try with four pieces at once. I found here that doing the rough …
Close up of cutting four ellipses at once

Made using

Used for