A selection of Mark's enamel work
Trivet after firing

A Trivet for Elliptical Plaques

A trivet made specifically to support the elliptical plaques during firing. Enamel on steel at this size wants to move in the kiln, and a plaque needs holding at its edges without the support marking the enamel.

Written about

How it was made

Recycling stainless steel
I've used the stainless steel off an old set of Ikea scales. It should …
Cutting the edges parallel
The main section of the trivet needs to have parallel edges since these will …
Another support foot
Support foot
Support foot before right-angle bend
Holding a foot in the vice
The foot is ready to be bent to get the right-angle.
Hammering action shot
Hammering in the vice
Finished hammering a right angle on support foot
All the feet ready

Used for